British Gas ICC2 combi ZWBR 11-37 ICC2, Инструкции по установке и обслуживанию

Страница: 13 / 148

6 720 610 602 GB (03.02)
Installation
13
Cupboard/Compartment
The appliance can be installed in a cupboard/compart-
ment need for airing clothes providing that the require-
ments of BS6798 and BS5440:2 are followed. The low
casing losses from the appliance eliminate the need for
ventilation openings in the compartment.
3.5 Wall mounting frame assembly
B
Take the wall mounting frame out of the package and
screw together with 6 screws as shown in fig. 7. Use
the outer lugs on the top and bottom horizontal sec-
tions for the appliances that are 512 mm wide.
Fig. 7
B
Hold the wall-mounting frame against the wall ensur-
ing that it is vertical.
B
Mark the position of the flue duct hole if a rear flue is
to be used. Refer to fig. 1 and 16.
B
Mark the holes for the wall mounting frame onto the
wall, drill and plug the holes and screw the wall
mounting frame to the wall with the screws provided.
Fig. 8
B
Screw the pre-plumbing manifold with two screws to
the wall mounting frame.
Fig. 9
3.6 Pre-piping the system
Fig. 10 Manifold
43 CH flow
47 CH return
112 Gas cock
171 Domestic hot water
172 Cold water relief
B
A drain tap should be fitted at the lowest point of the
central heating system.
B
WRAS approved filling loop must be fitted.
6 720 610 597-06.1O
6 720 610 597-07.1O
6 720 610 597-08.1O
200
260
6 720 610 576-06.1O
35
120-130
50
47 43
172 112 171