British Fires Berkshire L30G, Инструкция по установке и эксплуатации

Страница: 8 / 16

FIXING THE APPLIANCE
After having selected the final mounting
position of the appliance, taking into
account the site requirements as speci-
fied in section 4 of these instructions,
the integrity of the wall, and the feasibil-
ity of the proposed supply pipe routing,
the firebox of appliance may be secured
to the wall. A fitting template is supplied
to assist with this.
Mark the positions shown as “Gas model
L30G” on the wall. If the appliance is to
be mounted on the inner leaf of a con-
ventional cavity wall, or a solid wall, drill
four holes using a 7mm masonry bit.
Insert the fibre wallplugs provided.
If the appliance is to be mounted on a dry lined wall or
a timber framed construction wall then special cavity
screw fixings will be required which are not supplied
with this product. These should be constructed from
metal and not plastic.
If a concealed gas connection is to be made ensure the
gas supply pipe is in it’s final position and can enter the
appliance in the correct position when the appliance is
hung on the wall.
Insert the wall fixing screws into the top wall plugs, tak-
ing care to leave the screws protruding approximately
10mm from the wall. Now hang the appliance onto
these screws through the two keyhole shaped holes in
the two upper brackets on the back-panel of the appli-
ance.
Insert the lower fixing screws into the lower wall plugs
through the corresponding fixing brackets in the lower
part of the back panel. Do not tighten fully.
Before tightening the wall mounting screws fully, at this
stage it is recomended to check the horizontal align-
ment of the appliance with a spirit level, as small ajust-
ments can still be made if necessary. When this has
been checked, tighten all four fixing screws fully. To
access the upper fixing screws insert a screwdriver through the holes in the deflector plates above the cat-
alytst as shown above.
CHECKING THE BURNER
There are no imitation fuel bed components to install. The appliance features a ribbon burner which is
designed to produce a continuous band of flame over it’s length.
The burner should be visually inspected to ensure it is free from any foreign matter.
If it is necessary to clean or dust off the burner then the glass door should be removed by removal of the
four retaining screws. Re-fit the glass door after cleaning or inspection, ensuring a good seal.
5
7.0
7.1
GAS MODEL
L30G