ENGLISH
USER MANUAL
BRITEQ
®
6/7
LED UV-GUN 100W
OPERATING INSTRUCTIONS
A. Standalone 1unit:
Just connect the projector to the mains.
Make the settings for the STANDALONE MODE
Refer to chapter HOW TO SETUP to learn how to make the these settings.
B. Two or more units in master/slave setup:
Connect several units
together. Refer to the chapter “electrical installation” to learn how to do this.
Select one of the STANDALONE MODES on the master (the first UV projector in the DMX chain)
Set all the other projectors in SLAVE mode.
The projectors will now follow the program of the master projector so they all work synchronously.
C. Controlled by universal DMX-controller:
Connect all units together. Refer to the chapter “Electrical installation for two or more units in DMX-
mode” to learn how to do this (don’t forget to address all units properly!)
Connect all units to the mains and turn on the DMX controller.
Since each unit has its own DMX-address, you can control them individually. Remember that each unit
uses 1 or 2 DMX-channels, depending on the DMX-mode you have selected in the menu. See the
different DMX charts below:
1CH MODE
Channel 1
Dimmer
000-255
0-100%
2CH MODE
Channel 1
Dimmer
000-255
0-100%
Channel 2
Strobe
000-007
Strobe OFF
008-200
Strobe speed (increasing)
201-255
Sound controlled Flashing (increasing sensitivity)
WIRELESS REMOTE CONTROLLER
IMPORTANT REMARKS:
The wireless IR-remote is NOT INCLUDED but can be ordered separately!
The wireless IR-remote is only active when NO DMX-signal is detected!
Not all buttons of the IR-remote are used!
Functions of the buttons:
DIMMING:
You can set the light output at 20%, 50% or 100%.
OFF = Blackout.
STROBE:
You can set the strobe speed at 20%, 50% or 100%.
Other buttons are NOT USED!
