LD-POWER240
BRITEQ
10A
5. Menu
Press the button to select the programming functions.
6. Up
Press the button to go forward for the desired functions.
7. Enter
Press the button to confirm the selected functions.
8. Down
Press the button to go backward for the desired functions.
9. Display
To show the various menu and selected function
10.Chase Group 1
Press the button to run chase group 1, the LED will be on.
11.Chase Group 2
Press the button to run chase group 2, the LED will be on.
12.Chase Group 3
Press the button to run chase group 3, the LED will be on.
13.Manual
Press the button into manual mode, the LED will be on.
14.Fade
Press the button into fade mode, the LED will be on.
15.Auto
Press the button into auto mode, the LED will be on.
16.Blackout
Press the button to blackout the unit, the LED will be on.
6.2 Rear View
1. FUSE
For protecting the unit when the transient current is too big.
2. POWER
Power cable for AC input.
3. DMX OUT
DMX Output 3 pin XLR socket
4. DMX IN
DMX Input 3 pin XLR socket
5. LED
DC power & signal output for linking LED fixtures.
LD-POWER240
BRITEQ
11A
7. DMX Controller
Using universal DMX controller to control the units, you have to set DMX address
from 1 to 512 channel so that the units can receive DMX signal.
Press the
MENU
button up to when the
Address
is showing on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the
DMX512 address. Once the address has been selected, press
ENTER
button to
setup (or automatically return to the main functions without any change after idling
one minute). Back to the previous function without any change, press
MENU
button.
Please refer to the following diagram to address your DMX512 channel for the first 4
units.
20 Channels:
19 Channels:
16 Channels:
12 Channels:
8 Channels:
5 Channels:
4 Channels:
