ENGLISH
OPERATION MANUAL
BRITEQ
®
3/6
BT-PROFILE250 LED ENGINE
•
In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
•
The housing and the lenses must be replaced if they are visibly damaged.
•
Please use the original packing when the device is to be transported.
•
Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
Important:
Never look directly into the light source! Don’t use the effect in the presence of persons suffering
from epilepsy.
OVERHEAD RIGGING
The projector can be put on any stable projector stand or you can hang it on the wall or ceiling. In that case
please follow the safety instructions below to assure proper installation!
•
Important:
The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
•
Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
•
Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed
at least 50cm
from surrounding walls.
•
The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
•
Before rigging make sure that the installation area can hold a minimum point load of 10time
s the device’s
weight.
•
Always use a certified safety cable that can hold 12 times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
•
The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
•
Don’t cover any ventilation openings as this may result in overheating.
•
The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
DESCRIPTION:
1. DISPLAY:
Helps you with the configuration of the LED ENGINE. The
backlight of the display starts flashing while the projector is in DMX-
mode and no DMX is detected.
2. MENU button:
used to browse the setup menu, with each button
press you go to the next item.
3. UP button:
used to change (increase) the value of the selected
feature.
4. DOWN buttons:
used to change (decrease) the value of the selected
feature.
5. ENTER button:
used to confirm th
e selected selection, don’t forget!
6. HANDLE:
used to point the projector in the desired direction.
7. MAINS FUSE:
protects the unit in case of electrical problems, always
use the prescribed fuse!
8. MAINS INPUT:
with PowerCON
®
socket; connect the supplied mains
cable here.
9. MAINS OUTPUT:
you can use this output to daisy chain several units,
up to max 16A. Input and output are connected to each other without any fuse.
Hint: Please check our website for special cable assemblies that contain both power (3x1.5mm² with
Neutrik PowerCON
®
) and balanced signal (XLR 3pin) in one cable. Different lengths are available: 1.3m,
3m, 5m and 10m, very convenient!
10. DMX INPUT CONNECTOR:
3pin male XLR-connector used to connect the unit with the DMX controller
or with the previous unit in the DMX chain.
11. DMX OUTPUT:
3pin female XLR-connector used to connect the unit with the next unit in the DMX chain.
