ENGLISH
USER MANUAL
BRITEQ
®
7/9
BT-NONAMOVE
[CALIBRATION] menu
This is a hidden menu where you can fine-tune the offset of several functions. To access this menu do as
follows: press the encoder for about 3seconds while you are in the SETUP menu (any option, not important).
Now the calibration menu shows up:
•
Turn and press the encoder wheel to select the desired menu item.
•
Turn the encoder wheel to adjust the calibration.
•
Press the encoder wheel to confirm.
Different calibrations can be done:
[CALIBRATION > Reset JOB]
Used to reset the
“
Last job
”
timer (this timer whows how long the unit was used on the last job)
•
Turn and press the encoder wheel to select the desired menu item.
•
Turn the encoder wheel to select [NO/YES]
[CALIBRATION > PAN / TILT ]
Used to adjust the [PAN / TILT] home positions:
•
Turn and press the encoder wheel to select the desired menu item.
•
[PAN]:
offset PAN movements
•
[TILT]:
offset TILT movements
•
Turn the encoder wheel to adjust the calibration.
•
Press the encoder wheel to confirm.
When all offset adjustments are done, press the
[MENU/ESC] button
to return to the regular setup menu.
ELECTRICAL INSTALLATION
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
ELECTRICAL INSTALLATION FOR TWO OR MORE UNITS IN DMX-MODE:
Use this function when you want to control the projectors by any DMX controller.
•
Connect the projectors as shown in the drawing below.
Some general information on DMX:
•
The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
“daisy chain” your DMX cont
roller and all the connected units with a good quality balanced DMX-cable.
Both XLR-3pin and XLR-5pin connectors are used, however XLR-3pin is more popular.
•
Pin layout XLR-3pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+)
•
Pin layout XLR-5pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+) ~ Pins4+5
not used.
•
To prevent strange behavior of the light effects, due to interfere
nces, you must use a 90Ω to 120Ω
terminator at the end of the chain. Never use Y-
splitter cables, this simply won’t work!
•
Make sure that all units are connected to the mains.
•
Each unit in the chain has its proper starting address so it knows which commands from the controller it
has to decode.
