ENGLISH
USER MANUAL
BRITEQ
®
5/9
BT-NONAMOVE
SETUP MENU
The setup menu of the BT-NONAMOVE is deliberately kept very small to allow quick installation with less
risk of incorrect settings. The display of the installed BT-NONABEAM is not used: internal communication
with the BT-NONAMOVE assures that all settings and information are handled by the BT-NONAMOVE.
Some of the specific settings for BT-NONABEAM can be set through its control channel.
•
Press the [MENU/ESC] button to enter the setup
menu.
•
Turn the encoder wheel to browse the main menus:
•
[SET CONFIG]
•
[INFORMATION]
•
[TEST]
•
Press the encoder wheel to select the desired sub
menu.
•
Turn the encoder wheel to browse the sub menus &
items.
•
Press the encoder wheel to select the desired menu
item.
•
Turn the encoder wheel to change the parameters.
•
Press the encoder wheel to confirm the new
parameters.
•
Press the [MENU/ESC] button jump to a higher
menu level.
[SET CONFIG] menu
Menu with all functions needed to setup the unit.
[SET CONFIG > DMX-Address]
Used to set the starting address.
•
Press the encoder wheel to select the desired menu item.
•
Turn the encoder wheel to change the parameters.
•
Press the encoder wheel to confirm.
Remark:
the installed BT-NONABEAM receives the corresponding DMX-address automatically.
[SET CONFIG > CHAN.Mode]
Used to set the desired channel setup mode.
•
Press the encoder wheel to select the desired menu item.
•
Turn the encoder wheel to select the desired option:
•
05CH:
only yoke control: used while the BT-NONAMIRROR is installed
•
18CH:
yoke c 13CH mode is automatically selected on the installed BT-NONABEAM
•
34CH:
yoke c 29CH mode is automatically selected on the installed BT-NONABEAM
•
50CH:
yoke c 45CH mode is automatically selected on the installed BT-NONABEAM
•
Press the encoder wheel to confirm.
[SET CONFIG > DISPLAY > AUTO LOCK]
Used to lock the setup menu against unwanted altering of the settings.
•
Press the encoder wheel to select the desired menu item.
•
Turn the encoder wheel to select the desired option: [ON/OFF]
•
Press the encoder wheel to confirm.
[SET CONFIG > DISPLAY > noDMX blink]
Used to select of the display should blink or not when the DMX signal was lost.
•
Press the encoder wheel to select the desired menu item.
•
Turn the encoder wheel to select the desired option: [ON/OFF]
•
Press the encoder wheel to confirm.
