ENGLISH
OPERATION MANUAL
BRITEQ
®
9/12
BT-COLORAY MULTI
Each time the projector is switched on, the display
shows “UPDATE Wait ….”: while this message shows on
the display you can start the update using our special upgrade tool. More information about this can be found
in the user manual of the upgrade tool and / or our website:
ELECTRICAL INSTALLATION
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Master / Slave mode:
Con
nect the projectors together as shown on the drawing. Please refer to the paragraph “SETUP MENU” to
setup the master. You can also switch the IR-remote on the master to ON and use the included IR-remote.
All slaves must be set to SLAVE-mode. You can put as many slaves as you like on condition that the overall
power consumption on the power line stays under 10A (2300W).
IMPORTANT: make sure that no DMX-controller is connected, this will result in unexpected behavior!
Electrical installation for two or more units in DMX-mode:
•
The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
“daisy chain” your DMX controller and all the connected units.
•
Pin layout XLR-3pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+)
•
To prevent strange behavior of the ligh
t effects, due to interferences, you must use a 90Ω to 120Ω
terminator at the end of the chain. Never use Y-
splitter cables, this simply won’t work!
•
Make sure that all units are connected to the mains.
•
Each unit in the chain needs to have its proper starting address so it knows which
commands from the controller it has to decode. In the next section you will learn how
to set the DMX addresses.
RDM FUNCTIONS / REMOTE SETUP
RDM
means “
R
emote
D
evice
M
anagement”. This projector works with a brief set of RDM-functions which
means that it can setup a bi-directional communication with an RDM-compatible DMX-controller. Some of
these functions are briefly explained below, others will be added in the future.
•
The DMX-
controller sends out a “discovery command”, all RDM devices respond and send their unique
device ID.
•
The DMX-controller asks each RDM device for some basic data so it knows which devices are connected.
The projector will respond:
•
Device name:
BT-COLORAY MULTI
•
Manufacturer:
Briteq®
•
Category:
LED Dimmer
