Briteq B06030, Руководство по эксплуатации, Страница: 5 / 15

ENGLISH OPERATION MANUAL
BRITEQ
®
3/12 BT-THEATRE 200TW
DESCRIPTION:
1. MAINS INPUT: equipped with PowerCON ® compatible connectors. Connect the supplied mains cable or
any PowerCon ® extension cable here.
2. MAINS OUTPUT: used to daisy chain the power to several other projectors. Always pay attention to the
maximum load while adding projectors! Special Multi cables (PowerCON
®
+ DMX XLR-cables are optionally
available: see our website!)
3. MAINS FUSE: protects the unit in case of electrical problems, always use the prescribed fuse!
4. DMX IN/OUT: both 3pin and 5pin in/outputs are available to daisy chain the projector with other units that
will be controlled by a DMX-controller.
5. M-DMX INPUT: Please note that this USB-connector is NOT used for updates or to connect the unit to a
PC! Instead this USB-connector makes it very easy to add wireless DMX to the unit! Just add the (optional)
WTR-DMX DONGLE from BRITEQ
®
and you will get wireless DMX! Moreover, you will be able to connect
other DMX-controlled equipment to the DMX-output so you can share the wireless DMX function with all
connected units! No extra settings to be made in the setup menu, just follow the procedure in the user
manual supplied with the WTR-DMX DONGLE from BRITEQ
® . The separate WTR-DMX DONGLE is
available from WWW.BRITEQ-LIGHTING.COM (order code: 4645)
6. DISPLAY:
shows the various menus and the selected functions.
7. MENU-button: used to enter and exit the setup menu or to jump to a higher level in the setup menu.
8. ENTER-button: used to select a menu option or confirm a setting.
9.
▲-button:
used to go to the previous menu option or to increase a parameter value.
10.
▼-button:
used to go to the next menu option or to decrease a parameter value.
11. ENCODER: used to easily use some handy functions:
•
DMX-mode: Press the encoder to set the
output at 100% during 10 sec. Very handy
for aligning and adjusting the light beam in a
theatre!
•
MANUAL-mode: see the drawing to easily
understand how to use the encoder:
o
CHANGE DIMMER LEVEL: turn the encoder to change the light output manually. Press the
encoder shortly if you want to save the new light output for future use.
o
CHANGE CCT: press the encoder until the display shows [LED CCT]. Turn the encoder to
select the desired CCT. Press the encoder shortly if you want to save the new CCT for future
use. Press the encoder again for +/-2 seconds to return to dimmer level.
12. HANDLE: used for aligning the spotlight. Can also be used to attach the safety cable during installation,
see paragraph “overhead rigging”.