Britax ISOFIX COMPATIBLE, Инструкция по эксплуатации

Страница: 24 / 92

Instructions for Installation & Use
24
IS THERE ENOUGH ROOM ?
To ensure that the space is sufficient, the
purchaser should check the measurements
between the vehicle’s rear and front seats in
which the child restraint is intended to be used
for both rear facing mode and forward facing
mode.
DO NOT USE RESTRAINT IN REARWARD
FACING MODE WITHOUT THE REBOUND
BAR FULLY EXTENDED.
Do not use the restraint without the top
tether strap correctly attached.
DO NOT USE A REAR FACING CHILD
RESTRAINT WHERE AN AIRBAG IS FITTED
IN FRONT OF THE SEATING POSITION.
Do not use on any vehicle seat which faces
sideways or rearwards.
CHILD SEAT UPPER ANCHORAGE POINT
This child seat must be installed using the top tether. The top tether will need to attach to the
appropriate upper anchorage point for both rearward and forward facing modes. Refer to the
car owner's handbook for anchorage locations or points. If your vehicle does not have an
upper anchorage point then you will need to install an upper anchorage point. Refer to pages
82 to 86.
Do not allow the front seat to alter
the installed angle of the restraint.
SETUP
- GENERAL INFORMATION
FOR REARWARD FACING
520mm
375mm
REARWARD FACING
MEASUREMENTS
Width 440mm