Installation
13
Installation
12
5
Line up LATCH connectors with
LATCH anchors on vehicle seat
(
Fig D
).
6
Push from behind red button on
each connector to attach to LATCH
anchor (
Fig E
).
NOTE:
LATCH connectors are
correctly attached when a positive
click is heard. If a positive click is
not heard, repeat steps 2–6.
7
Push restraint into vehicle seat
until firm against the seat back (
Fig
F
).
8
Verify that all connections are
tight and the child restraint is
secure.
Installation can be improved by the
use of the Versa-Tether
™
(
see
page 16
).
R
Reem
moovvaall
1
Squeeze the green and red
LATCH release buttons on each
connector to release.
2
Replace protective cover by attach-
ing it to the LATCH connectors.
3
Push LATCH connector assem-
bly in to store.
D
E
F
LLaapp-SShhoouullddeerr B
Beelltt IInnssttaallllaattiioonn
Figure A
illustrates a typical lap-
shoulder seat belt configuration.
NOTE:
Protective cover should be
in place when LATCH is not in use.
1
Place the child restraint forward
facing on the vehicle seat.
2
Pull the vehicle belt out, then hold
the lap and shoulder sections togeth-
er. Keep the sections together as you
pass the seat belt through each for-
ward facing belt slot (
Fig. B
).
3
Fasten the seat belt, then verify
that the seat belt is not twisted
(
Fig. C
).
4
Flip lock-off arm down to release.
NOTE:
Although the child restraint
has two forward facing lock-offs,
you will only need to use one.
Always use the lock-off that is far-
thest away from where the seat
belt is buckled.
Shoulder
Lap
B
A
C
P2170_EXP_R01.qxd 5/21/2007 9:31 AM Page 14
