BRISTERS CHUCK WAGON, Руководство оператора

Страница: 22 / 68

22
(part #20843). Torque the oil drain plug to 9
ft*lbs.
Remove 1. Remove the oil drain plug located on the
bottom of the gearcase using a ¼” hex key
4.
wrench.
5. Add 150 ml. (5 oz.) of Mobil fluid 424
6. Reasse
and torque to 10 ft*lbs.
Gear Spacing adjustment
sistance.
Rear Tr
the oil b
page 18
90˚
oil be ch
nch.
ut of the unit. Catch and
discard the oil properly.
ain
plug and reinstall. Torque oil drain plug to 10
ft*lbs.
4. Remove the oil fill plug using a ¼” hex key
wrench.
5. Add 200 ml. (7 oz.) of 80W90 gear oil.
oil fill plug into the gearcase
ft*lbs.
the oil fill plug using a 5/16” hex key wre
2. Let all the oil drain o
Brister’s part # 20848 ( note: do not use any
other type of oil in this system or the 4WD
will not
3. Be sure to clean off any debris on the dr
operate properly!)
mble the oil fill plug into the gearcase
6. Reassemble the
and torque to 10
1. Locate set screw on front gear box.
2. Turn clockwise until you feel re
3. Turn back counter clockwise ¼ turn.
ansaxle Gear Box – It is recommended that
e changed once a year or after 600 hours. See
of owner’s manual.
Transfer Gear Box – It is recommended that the
anged once a year or after 600 hours.
Strut ball joint lube – It is recommended that the
lower strut ball joint be lubricated every 3 months or
after driving in water, mud or dusty conditions. The
t. grease fitting is located on the back side of the stru
(see photo)
Transfer
Gear Box
Oil fill
Gear
Spacing
Adjusting
Screw
Grease
fitting