22
23
Commissioning - Testing the System
Warning: Before using the shower for the first time, it should
receive a final flush through to remove any remaining debris that
may be in the pipe work or hose and to ensure the heater unit
contains water before the electrical elements are switched on.
Remove the showerhead from the hose and if not already attached,
attach the hose to the outlet port and ensure that the outlet hose
mesh filter is fitted.
The temperature control knob (2) must be set to number 5.
Turn on the water supply and inspect for water tightness.
Turn on the mains electrical supply to the shower.
Purge Procedure
Before using this shower for the first time the purge procedure
should be carried out. The following step should be followed;
1.
Ensure Unit is isolated from the electricity supply.
2.
Remove front cover.
3.
Set Dip Switch ‘NU1’ to ‘On’ and set the Front Face dial to ‘1’.
4.
Replace the cover.
5.
Restore power to Unit, and press START/STOP button. ‘FC’ will
flash on the display.
6.
Commissioning / Purge Sequence will now resume.
a) 10s no water flows
b) 30s running water
c) 10s pulsing water
d) 30s running water
e) Shower will display ‘FC’ permanently on when the
Commissioning / Purge Sequence is complete.
7.
Isolate shower from the electricity supply.
8.
Remove Front Cover and restore Dip Switch to original settings.
9.
Replace Front Cover, restore power to Unit. Shower is now ready
for normal use.
Once you are satisfied that the system has been flushed through
thoroughly, press the START/STOP button (3) to stop the flow.
Note:
If the letters LP appear on the front panel in
the display area (1) this indicates low water supply
pressure to the unit. Please switch off unit until
water pressure increases before continuing to use
the shower.
Re-fit the showerhead to the hose, insert hose rubber washer to
seal the joint; please ensure that the hose passes through the
larger hole in the soap dish. The showerhead is attached to the riser
rail by inserting the conical hose end into the movable slider.
Your shower is now ready for first use.
Need help?
Give us a call on
0844 701 6273
and speak to one of our trained advisors.
1
2
3
4
5
6
7
8
9
joy care
joy care
joy care
Start / Stop
eco
2
3
1