06
8. Fault Diagnosis
8. Fault Diagnosis
8. Fault Diagnosis
8. Fault Diagnosis
If your valve fails to function correctly, the following should
If your valve fails to function correctly, the following should
If your valve fails to function correctly, the following should
If your valve fails to function correctly, the following should be checked:
be checked:
be checked:
be checked:
1.
Check that the hot and cold connections are the correct way around. Hot on the left and Cold on the right
(when viewed from the front).
2.
Ensure that the hot water temperature is adequate; the recommended minimum temperature is 60ºC. The
hot water temperature should be at least 10ºC higher than the blend temperature to ensure that the safety
shut off will work.
9. Cleaning & Maintenance
9. Cleaning & Maintenance
9. Cleaning & Maintenance
9. Cleaning & Maintenance
Your fitting has a high quality finish and should be treated with care to preserve the visible surfaces.
All finishes will wear if not cleaned correctly. The only safe way to clean your product is to wipe with a soft damp
cloth. Stains can be removed using washing up liquid. All bathroom cleaning product (powders and liquids) will
damage the surface of your fitting, even the non-scratch cleaners.
NOTE:- Never use abrasive detergents or disinfectants or those containing alcohol, hydrochloric or phosphoric
acid.
We advise that your fitting is regularly serviced, particularly in hard water areas.
Maintenance
Maintenance
Maintenance
Maintenance –
–
–
– (See Fig 2)
(See Fig 2)
(See Fig 2)
(See Fig 2)
Should the valve need to be dismantled for maintenance then the procedure is:
1. Turn off both water supplies.
2. Remove cap (E), remove the screw (D) and remove the temperature handle (C) and collar (D).
3. Unscrew the grub screw (F) on the underside of the body to remove the temperature control cartridge (E), which
pulls out, and check its condition i.e. Valves and seals.
4. Reassemble the cartridge after having cleaned the inside of the valve body and the cartridge.
5. For the flow control, remove the cap (G), making sure the water supply is turned off remove the handle retaining
screw (H), and pull off handle (I). Unscrew the valve (J) using a suitable spanner and check for wear, damage or
debris.
6. Reassemble the valve after cleaning.
7. Replace handle and components and turn on the water supplies.
Bristan recommend E-Cloth for cleaning all of our bathroom & kitchen products.
Using just water, E-cloth gives a smear free, deep clean by breaking up and
holding dirt, which normal cloths leave behind. Order through your Bristan
stockist.
(ORDER CODE: ECLOTH)
