5. Installation
5. Installation
5. Installation
5. Installation –
–
–
– (See Fig 1)
(See Fig 1)
(See Fig 1)
(See Fig 1)
5.1 Place the sealing washer (2) into the connecting nut (1) and tighten nuts onto the pillars (3).
5.2 Fit the pillars (3) to the bath using back nuts (5) and washers (4). The flow control should be on the left and the
temperature on the right with the outlet underneath.
5.3 Connect water supplies to pillars (3). Hot on the left and Cold on the right
Hot on the left and Cold on the right
Hot on the left and Cold on the right
Hot on the left and Cold on the right (when viewed from the front).
6. Operation
6. Operation
6. Operation
6. Operation
The flow handle controls the amount of water and the temperature handle controls the temperature of the water.
The Valve is pre-set to 38ºC however this can be overridden, See setting section.
To switch from bath to shower mode, pull the diverter up. After use the mixer automatically reverts to the bath
filling mode.
7. Setting
7. Setting
7. Setting
7. Setting –
–
–
– (See Fig 2)
(See Fig 2)
(See Fig 2)
(See Fig 2)
The temperature is factory set at 38ºC, however this maybe overridden by simply depressing the red button on the
temperature handle when it reaches the stop and continue to turn the handle anti-clockwise until the desired
temperature is found. This can however be adjusted for site conditions or personal preference by following the
below instructions:
•
Remove the cap (E).
•
Remove the screw (D).
•
Remove the handle (C).
•
Turn the spindle in the required direction to increase or decrease hot or cold temperature.
•
Replace the handle so that the stop inside the handle rests against the stop / shoulder on collar (B).
•
Replace the screw (D) and cap (e).
Fig. 1
Fig. 1
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 2
Fig. 2
05
