Brinkmann Vertex Sear 810-3885-G, Руководство пользователя

Страница: 17 / 59

16
TROUBLE SHOOTING:
Problem Possible Cause Prevention/Cure
Burner will not light Gas tank valve is closed Make sure regulator is securely attached to the gas tank, turn gas
tank valve to “OPEN”
Gas tank is low or empty Check if gas tank is empty. If empty, replace or refi ll.
Gas leak 1. Turn gas tank valve to “CLOSED”
2. Wait 5 minutes for gas to clear
3. Follow “Leak Testing” in the owner’s manual
Coupling nut and regulator not fully connected See section on “Connecting Hose and Regulator”
Obstruction of gas fl ow 1. Clean burner assembly
2. Check for bent or kinked hose
Burner may not be properly seated Reseat burner and valve. Refer to “Burner Assembly/Maintenance”
instructions
Spider webs or insect nest in venturi Clean venturi and burner assembly
Burner ports clogged or blocked Clean burner ports
Battery needs to be changed Replace the battery (follow assembly step for inserting battery)
Wires or electrode covered with cooking residue Clean wire and/or electrode with rubbing alcohol
Electrode and burners are wet Wipe dry with cloth
Electrode cracked or broken - sparks at crack Replace electrode
Wire loose or disconnected Reconnect wire or replace electrode/wire assembly
Wire is shorting (sparking) between ignitor and
electrode Replace ignitor wire/electrode assembly
Bad ignitor Replace ignitor
Grill does not get hot
enough Out of gas Replace or refi ll gas tank
Irregular fl ame pattern.
Flame does not run full
length of burner Burner ports are clogged or blocked Clean burner ports
Flame is yellow or orange New burner may have residual manufacturing
oils Burn grill for 15 minutes on “HIGH” with the lid closed
Spider webs or insect nest in venturi Clean venturi and burner assembly
Food residue, grease, etc. Clean burner assembly
Poor alignment of valve to burner venturi Make sure burner venturi is properly engaged with valve
To see trouble shooting or assembly videos, visit us at: