Brinkmann Vertex Sear 810-3885-G, Руководство пользователя

Страница: 10 / 59

9
6. Repeat steps 3–5 for lighting each burner. Always use electronic igniter for lighting each burner. If
burner does not ignite using the push-button igniter, wait 5 minutes, see “Match Lighting the Main
Burners” section.
7. To turn off, turn each control knob clockwise until it locks in the “ ” (OFF) position. This does not turn
off the gas fl ow from the cylinder.
Note: Vertex Sear Burner must be “OFF” to use the two lower burners. The two burners under the
Vertex Sear Burner will not turn ON when the Vertex Sear Burner is in the “ON” position.
Note: If burner does not light or fl ame is too low, See “Trouble Shooting” section of the owners manual.
MATCH LIGHTING THE SMALL AND LARGE FIREBOXES:
1. Open lid before lighting burner.
2. Turn the burner control knobs to “ ” (OFF).
3. Place paper match in the end of the matchlighter. Strike the match
and place through cooking grill and under heat tent approximately
1 to 2 centimeters from the burner to be lit.
4. Push and turn the control knob of that burner to the “ ” (HIGH) position.
The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to “ ” (OFF) and wait
5 minutes for gas to dissipate and repeat lighting procedure.
6. To light other burners, repeat steps 3–5 for each burner.
7. If the burner does not light within the fi rst few attempts of match lighting, there is a
problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT
attempt to operate the grill until the problem is found and corrected.
Note: If burner does not light or fl ame is too low, See “Trouble Shooting” section
of the owners manual.
LIGHTING THE SIDE BURNER:
1. Slide to open lid before lighting side burner.
2. Make sure control knob is in the “ ” (OFF) position.
3.
Push and turn side burner control knob to the “ ” (HIGH) position.
4. Press the electronic igniter on the main control panel and hold for
3–5 seconds to light burner.
5. If ignition does NOT occur in 5 seconds, turn control knob to
“ ” (OFF), wait 5 minutes to allow gas to dissipate and repeat
lighting procedure.
6. If burner does not ignite using the push-button igniter, wait 5 minutes,
see “Match Lighting the Side Burner” section.
7. To turn off, turn control knob clockwise until it locks in the “ ” (OFF)
position.
Note: If burner does not light or fl ame is too low, See
“Trouble Shooting” section of the owners manual.
MATCH LIGHTING THE SIDE BURNER:
1. Slide to open lid before lighting side burner.
2. Turn the burner control knob to “ ” (OFF).
3. Strike and carefully place a match approximately 1 to 2 centimeters
from the burner.
4. Turn the side burner control knob to the “ ” (HIGH) position. The burner
should light within 5 seconds.
5. If the burner does not light, turn the control knob to “ ” (OFF) and wait
5 minutes for gas to dissipate and repeat lighting procedure.
6. If the burner does not light within the fi rst few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected. See “Trouble Shooting” section of this manual.
Note: If burner does not light or fl ame is too low, See “Trouble Shooting” section of the owners manual.
Matchlighter
Matchlighter