40
Step 7
Figure 1 shows valve stem and bezel
with the control knob removed. Take
six large stop plates from the
component card and place them over
the valve stems as illustrated
(Figure 2). Verify the tab and the
stamped letter on the stop plates face
out. Replace control knobs when
finished.
WARNING:
We recommend and
request that you do not remove the
control panel in order to access the
valve tips. If you choose to remove
the control panel, you must replace
the control panel bezels exactly as
illustrated in Figure 2. Failure to
replace the bezels as illustrated could
lead to personal injury and/or property
damage.
Step 8
Carefully replace each burner, making
sure burner openings slide over valve
nozzles. Screw each main burner
"foot" down using screwdriver and
screws that were set aside in Step 4.
Replace cotter pin in side burner
“foot” that was set aside in Step 2.
Step 9
Replace warming rack, cooking grills,
heat shields and grease tray.
Note:
Follow directions in the leak
testing section of this manual
before using this grill.
Warming Rack
Cooking Grills
Heat Shields
Stop Pin
L
Figure 2
Figure 1
Stop Plate
Tab
