Brillion Field Commander HFC16, Руководство оператора, инструкции по сборке, Страница: 61 / 64

2K314
Wings do not fold properly
Too fast Make sure restrictors are installed in the circuit.
Too slow Check tractor flow adjustment and hydraulic
pressure. 1500 PSI is required to fold large
machines with spike tooth harrows mounted to
rear tooth bar.
Make sure hydraulic hose ends are functioning
properly, if not, replace.
Wings are not even when folded Center the cylinder anchor on the rear tooth bar.
Center the wing support on the front tooth bar.
Cylinder leakage, external or internal Repair or replace the cylinder.
Plugging
Incorrect shank location Refer to shank locating charts on pages 32, 33,
34, and 35.
Plugging at wheel with S-tine Be sure to use shank mount to locate S-tine
rearward in the area next to the tire. See the
shank locating charts on pages 32, 33, 34, and
35.
Too much trash Operate at an angle to the rows if possible. Make
sure that your combine is spreading the stalks. In
extreme conditions it may be necessary to shred
or disk the stalks before cultivating.
Tire and shank interference
Tire strikes S-tine in transport position Use the hole in walking beam which will position
the inner wheel farthest from the wheel arm.
Tire strikes sweep Check shank spacing charts.
Only 7 inch wide sweeps can be used in the area
adjacent to tires.
Cultivator does not follow properly
Machine is not leveled properly Level the cultivator front to rear and side to side.
See level adjust, page 7.
Incorrect shank locations See shank locating charts on pages 32, 33, 34, &
35.
Unequal tire diameters Check tire diameters and inflation pressures.
Towed implement is causing side loading Check operation of any implement you are towing
194rev3-4-05 Page 47