Brillion Field Commander HFC16, Руководство оператора, инструкции по сборке, Страница: 14 / 64

2K314
Prepare the machine for field operation
1. Raise the machine fully on its transport wheels.
2. Remove the transport locks on both center axle lift cylinders and place them in their stor
age position. See figure 3.
3. Lower the wings by extending the wing lift cylinders. Make sure that the cylinders are
extended completely, this will allow the wings to float down to follow the contour of the
ground.
Operating depth adjustment
1. With the machine leveled, the transport locks removed, and the wings unfolded, set the
approximate working depth by adjusting the cylinder anchor brace rods. See figure 6.
The scales on the anchor adjust rods are used to make sure that the brace rods are set
equally. The wing operating depth can be adjusted independently of the center section
by changing the anchor rod length as required. Shortening the brace tube raises the wing,
decreasing the operating depth. Lengthening the brace tube increases operating depth.
Note: The wing operating depth of 16 through 19 foot wide machines is controlled by
pinning the gage wheel adjust bar where required.
Note: Lower the machine onto the shanks to turn the adjust tubes.
Important: Adjust both anchor braces on the center section equally. Unequal length
braces will put a strain on the center axle, center frames, and on hydraulic cylinders.
FIGURE 5
194rev3-4-05 Page 11