7K116
Figure 2A
SAFETY DECALS
1.
2K123 - Moving Parts Warning
2.
8J310 - Caution Decal
3.
4K031 - Thrown Object Warning
4.
5D019 - 540 Transmission Caution
5.
2J431 - Reflective Amber
6.
2J430 - Reflective Red
7.
7K010 - Lifting Instructions
8.
3K696 - Danger Rotating Driveline
9.
7K009 - Danger Gurard Missing
MOVING PART HAZARD
TO PREVENT SERIOUS INJURY
FROM MOVING PARTS:
•
KEEP COVERS CLOSED DURING
OPERATION.
•
DO NOT ALLOW ANYONE TO RIDE
OR CLIMB ON MACHINE DURING
OPERATION.
•
KEEP OBSERVERS AWAY.
CAUTION
2K123
THROWN OBJECT HAZARD
TO PREVENT SERIOUS INJURY OR DEATH
FROM THROWN OBJECTS, KEEP AWAY
FROM DISCHARGE AREA DURING
OPERATION.
KEEP OTHERS OUT OF VICINITY WHILE
OPERATING.
4K031
KEEP AWAY!
WARNING
3
2
1
OVERSEEDER DECALS
4
5
THIS TRANSMISSION BOX
FOR 540 RPM ONLY!
CAUTION
5D019
3K696
DO NOT OPERATE WITHOUT-
DANGER
•
ALL DRIVELINE, TRACTOR, AND
EQUIPMENT SHIELDS IN PLACE.
•
DRIVELINES SECURELY ATTACHED
AT BOTH ENDS
•
DRIVELINE SHIELDS THAT TURN
FREELY ON DRIVELINE
DANGER- ROTATING DRIVELINE
CONTACT CAN CAUSE DEATH
KEEP AWAY!
9
8
GUARD MISSING
DO NOT OPERATE
DANGER
7k009
GUARD MISSING
DO NOT OPERATE
DANGER
DANGER
CAUTION
1. DO NOT LUBRICATE, ADJUST OR REPAIR WHEN MACHINE IS IN MOTION.
2. DO NOT TOW OR TRANSPORT FASTER THAN 15 MILES PER HOUR.
3. DO NOT RIDE OR ALLOW OTHERS TO RIDE ON THE MACHINE.
4. BLOCK UP ALL HYDRAULICALLY OR MECHANICALLY RAISED COMPONENTS TO
PREVENT UNINTENDED LOWERING OR LOWER THE MACHINE TO THE GROUND TO
MAKE ADJUSTMENT OR REPAIRS WHEN NOT IN USE.
5. KEEP ALL PERSONS AWAY FROM MACHINE DURING HITCHING AND OPERATING.
6. SLOW DOWN BEFORE MAKING SHARP TURNS OR USING THE BRAKES.
DRIVE SLOWLY OVER ROUGH GROUND, SIDE HILLS, AND AROUND CURVES TO AVOID TIPPING.
7. COMPLY WITH ALL LAWS WHEN TRANSPORTING THE MACHINE ON PUBLIC ROADWAYS.
8. INSTRUCT ALL OPERATORS IN THE SAFE OPERATION OF THE MACHINE.
REVIEW THE OPERATOR’S MANUAL FOR CORRECT PROCEDURES.
9. BLOCK IMPLEMENT TO PREVENT MOVEMENT WHEN UNHITCHED FROM TRACTOR.
10. KEEP ALL GUARDS AND SHIELDS IN PLACE WHILE MACHINE OR PARTS ARE IN MOTION.
8J310
CAUTION
Page 6
900rev7-11-03
MAX LIFT HEIGHT
TO AVOID DAMAGE TO POWER TAKE OFF SHAFT JOINTS
THE OPERATING ANGLE OF THE PTO SHAFT SHOULD NOT BE STEEPER THAN
30 DEGREES WHEN THE SHAFT IS TURNING. SET LIFT STOPS ON THE THREE
POINT LIFT ACCORDING TO THE CHART BELOW. THE OVERSEEDER CAN BE
TRANSPORTED IN A HIGHER POSITION WITH THE POT DISENGAGED. DO NOT
ENGAGE THE PTO BEFORE LOWERING THE MACHINE.
TRACTOR PTO
SHAFT HEIGHT
TRACTOR PTO
SHAFT HEIGHT
MAXIMUM LIFT
HEIGHT
21”
9 ”
22”
10”
23”
11”
24”
12”
25”
13”
26”
or Greater
14”
30
O
7
6
