Brightlink BLIP-A300TR-P-P, Руководство пользователя

Страница: 28 / 51

BRIGHTLINK 4K IP AV DISTRIBUTION
23
b) Selecting the respective TX will highlight all the receivers joined to the same TX.
2) If the respective Transmitter (TX) is currently not joined to the Receiver (RX),
proceed to join them:
a) In the Transmitter (TX) section, select a TX by left-clicking on its associated
active tile.
b) Drag and drop the TX tile over the RX tile to join them.
c) TX and RX are now joined together.
d) Repeat above steps, if additional receivers are to be joined to the same TX.
To control, if the HDMI audio is being delivered on the HDMI or the analog output port,
complete the following steps:
1) Right click the gear icon on a Receiver (RX) tile and select "Settings" in the menu.
2) To route audio to the HDMI output, select the "HDMI Audio Output" tab and then
choose one of the following options:
a) Analog Audio: Select the stream from the analog audio input of the TX to embed
it into the HDMI output signal.
b) HDMI Audio (Stereo Downmix): Select the audio stream from the HDMI input of
any TX to embed it into the HDMI output signal. If the HDMI audio stream is
multichannel PCM audio, it will be downmixed to 2-channel PCM audio.
c) HDMI Audio (All Available Channels): Select the audio stream from the HDMI
input of any TX to embed it into the HDMI output signal. The multichannel HDMI
audio will not be downmixed.
3) To send the audio to the analog output connector (mini XLR), select the "Analog
Audio Output" tab and choose "HDMI Audio (Downmix)" from the pull-down menu.
4) Click "Save" to apply changes.
5) The sound device connected to the analog audio output of the RX will now play out
the HDMI audio stream.
Note: Downmixed 2-channel audio is not available for proprietary Dolby or DTS audio
formats.