M3500 Issue 2 - Feb 2006
Last reviewed: Oct 2010 / Next review Oct 2013
9
1. INTRODUCTION
1.1
Receipt and Unpacking
This instrument received a final test and inspection prior to despatch from the factory. The
following instructions are given for the re-assembly of the instrument, adjustments and its
correct use. If the instrument is received before preparations for installation are completed, it
should be stored in a clean, dry place and not exposed to dirty or damp conditions.
1.1.1 Receipt
Immediately upon receipt of the instrument, make a careful examination for evidence of
damage encountered in transit. If any damage is found or suspected, notify both the carrier
and Bright Instrument Company Limited.
1.1.2 Unpacking
All packing must be carefully removed and parts checked against the enclosed packing list. If
any damage or discrepancy is noted, please inform our agent/distributor, or Bright Instrument
Company Limited, direct, immediately.
1.1.3 Lifting
The instrument has been designed with two main lifting points as hand holds at the front and
rear of the instrument. The instrument weight less than 25Kgs, but care should be taken when
lifting by following manual handling guide lines. If in doubt contact your Health & Safety
Officer.
1.2
ASSEMBLY AND INSTALLATION
The microtome is delivered virtually ready for use with only the accessories required for use in
need of fitting.
1.2 Electrical
connections
1.2.1 Electrical
requirements
The supply cord of the instrument should be connected to any ordinary electrical outlet (max
13 amps). Check the voltage stamped on the nameplate, located on the underside of the
instrument, with your supply:
The connections are:
Brown
- Positive
[live]
Blue
- Negative
[neutral]
Yellow/Green -
Earth [ground]
1.2.2 Electrical
Safety
Where earth connections are taken through connectors, then the connector must be rated to
take the maximum fault current. The machine should be disconnected before such connectors
are separated for servicing purposes.
1.2.3 Switching
on
Switch on by using the Mains Power switch located on the rear fuse panel. This is applicable
only to Motorised Advance/Rewind models.
For instruments with a section counter only, this is operated by 2 AA batteries located on the
rear panel at the bottom of the plinth.
2. OPERATING
INSTRUCTIONS
On receipt of your new Bright instrument, please refer to section 1.1 (Receipt and Unpacking)
and section 1.2 (Assembly and Installation).
