Bright Instruments
15
3. Anti-Roll Plate
Assembly
The Anti-roll Plate (ARP) is probably the
most important accessory to obtaining
good sections. Its correct adjustment and
maintenance are essential.
The ARP is set ready to use, but if adjustment
is necessary the following directions should
be followed:
Figure 9.
Anti Roll Plate
3.1 PARALLEL ADJUSTMENT
The top edge of the ARP must be parallel
to the blade. It can be adjusted by slightly
loosening screws (89) and moving the ARP
into position. Then tighten the screws.
3.2 HEIGHT ADJUSTMENT
The top edge of the ARP should be just above
the blade edge. If it is too low, the section
will curl up and fail to pass between the blade
edge and ARP.
To adjust the height of the ARP turn screw
(84)
Upward adjustment can be made with the ARP
against the blade; downward adjustment must
be made with it away from the blade. If the
ARP is moved downwards against the blade
the spacing registers will be cut away and the
AR will be damaged.
NOTE:
that the surfaces of the ARP and
the blade must be clean and free of grease,
frost or debris.
3.3 MAGNAPLATE ANTI-ROLL PLATE
The Magnaplate anti-roll plate can be used as
an alternative to the fixed anti-roll plate.
Figure 12a.
Figure 12b.
Magnaplate Anti-Roll Plate
Render
Render
