Briggs & Stratton 86262GS, Руководство по ознакомлению и устранению неисправностей

Страница: 106 / 128

104
• Install all the stator bolts by hand and only torque them
to “finger tight.”
• Then tighten them (Figure 4.34) to the specified torque
as outlined in the torque chart in the appendix of this
guide.
• Remove the spark plug from the cylinder head.
IMPORTANT:
Before proceeding to any other
step, check to make sure that no internal
obstructions are present. Pull the motor/generator
assembly through (Figure 4.35) several revolutions to
ensure that nothing is internally bound, grating or
rubbing.
Assembling The Wiring Harness
• Install the protective mesh over the power wires as
shown in Figure 4.36.
NOTE:
Refer to the specific wiring schematic that
applies to the unit you are working on, before
proceeding with the following steps.
• Push the appropriate “spade terminals” into their
designated compartments on the connector plug as
shown in Figure 4.37.
Section 4 • Generator Assemblies
Portable Generator Familiarization & Troubleshooting Guide
Figure 4.37 — Spade Terminals
Figure 4.34 — Install Stator Bolts
Figure 4.35 — Pull Test
Figure 4.36 — Install Mesh On Cable