Briggs & Stratton 86262GS, Руководство по ознакомлению и устранению неисправностей

Страница: 104 / 128

102
This notch aligns with a groove in the stator laminations
(Figure 4.27) that is approximately 1.5 inches long.
To ensure that the stator is properly mounted and aligned,
look for the following indicators:
• The stator wiring harness is located at the 9 o’clock
position.
• The notch in the engine adapter is indexed with the
groove in the stator laminations.
• The stator is seated squarely into the flange of the
engine adapter (Figure 4.28).
Installing The Rear Bearing Carrier
The index mark on the rear bearing carrier consists of a
“roll pin” pressed into the inside flange.Viewed from the
outside of the carrier, it would located at the 7 o:clock
position just inboard and slightly below the isolation mount
casting (Figure 4.29).
• Take note of the roll pin’s position and thread the
stator wiring harness through the cable grommet in the
rear bearing carrier as shown in Figure 4.30.
Section 4 • Generator Assemblies
Portable Generator Familiarization & Troubleshooting Guide
Figure 4.28 — Indexing The Stator
Figure 4.29 — Indexing The Rear Bearing Carrier
Figure 4.30 — Threading Harness Through Grommet
Figure 4.27 — Stator Alignment
Stator Alignment Groove
Wiring Harness
Notch & Groove