Briggs & Stratton 71 Piece Air Tool Kit, Руководство оператора

Страница: 16 / 44

14 BRIGGSandSTRATTON.COM
M Ma aiin ntte en na an nc ce e
Other than daily lubrication, air tools need little
maintenance.
• Use a soft cloth or shop towel to wipe off
any dirt or oil.
• Periodically inspect tool for cracks, oil leaks,
air leaks, or other conditions that could
make the tool unsafe. Should you detect one
of these conditions, contact your local
Briggs & Stratton authorized dealer.
Impact Mechanism Lubrication
Perform this lubrication process on the impact
tool once each month:
1. Detach any sockets or attachments from tool
and disconnect tool from air supply.
2. Using supplied Allen wrench, remove Allen
head screw from oil port hole marked “OIL”
on right side of impact tool.
3. Put three teaspoons of air tool oil in oil port.
Replace Allen screw.
4. Reconnect tool to air supply and run for
20 seconds. Lubricate entire impact
mechanism by rotating tool upside down
and sideways while running tool.
5. Detach tool from air supply and remove
Allen screw. Hold oil port hole over a rag or
container to allow excess oil to drain.
6. If drained oil is dirty, repeat steps 2 to 5
above until drained oil is clear.
7. Install Allen screw and tighten.
The residual oil remaining in the impact
mechanism is all that is needed for proper
lubrication.
Storage
The ratchet wrench, impact tool, die grinder and
air hammer must be lubricated before storing.
See
Air Motor Lubrication described in
Assembly but only run for 3 seconds instead for
20 seconds because more oil needs to remain
in the tool during storage.