Briggs & Stratton 71 Piece Air Tool Kit, Руководство оператора

Страница: 15 / 44

13
To use the air blow gun:
1. Attach the desired steel or brass nozzle to
the gun finger tight.
2. Connect air blow gun to air supply.
3. Put on safety goggles. Press trigger on air
blow gun and direct air stream at debris.
4. Sweep air stream back and forth to blow
debris out of the desired area.
An adapter is supplied to connect the rubber tip
air nozzle to the air blow gun.
Needle Inflator
To use a needle inflator to inflate a basketball or
volleyball, for example:
1. Connect air chuck to air supply.
2. Lubricate needle inflator with water or other
non-petroleum-based lubricant.
3. Gently and fully insert needle into air valve
on basketball.
4. Press air chuck over needle inflator and
permit air to enter bladder. Do not
overinflate.
5. Use an air pressure gauge (not supplied) to
establish recommended air pressure.
1/4 in. Hex Drive Bits
CAUTION Use 1/4 in. hex drive bits only with
the ratchet wrench. These bits are NOT rated for
impact tool use.
To use a 1/4 in. hex drive bit:
1. Attach 3/8 in. to 1/4 in. hex drive adapter to
ratchet wrench.
2. Press desired 1/4 in. hex drive bit into
adapter until fully seated.
3. Connect ratchet wrench to air supply.
4. Follow ratchet instructions given earlier.
• Always wear ANSI Z87.1 approved safety glasses with
side shields.
• Wear an ANSI approved dust mask or respirator
when working around metal, wood, and chemical
dusts and mists.
W WA AR RN NIIN NG G
Operating air blow gun causes flying
debris.
Air inflation tools could cause air
bladder to explode, causing flying
debris.