Briggs & Stratton 40213, Руководство по обслуживанию и устранению неисправностей

Страница: 58 / 76

Service & Troubleshooting Guide - Home Generator System - Models 040213 & 040234 (15kW)
Section 3 - Unit Disassembly Information
Page 58
3
9. Raise or lower the hoist until just the weight of the
alternator is supported by the lifting lug (Fig. 67).
Fig. 67 - Lifting The Generator Weight
10. On the outside corners of the rear bearing
carrier, tap the carrier evenly on all four corners
with a 52 oz. dead-blow hammer (Fig. 68).
Fig. 68 - Tapping The Rear Bearing Carrier
NOTE
: This will move the rear bearing carrier
away from the rotor bearing. During this process,
the stator can will separate from the rear bearing
carrier (while the rotor bearing has not yet come
free). When this occurs, begin tapping the lifting
lug on the stator can as well as the corners of
the carrier.
11. Alternate tapping on the lifting lug and the
corners of the rear bearing carrier until the stator
can comes free of the engine adaptor (Fig. 69).
Fig. 69 - Separating Stator From Engine Adaptor
12. Slide the rear bearing carrier and the stator off of
the rotor (Fig. 70).
Fig. 70 - Carrier and Stator Free Of Rotor
This leaves the rotor attached to the engine output shaft.
CAUTION
: Do not lift the entire engine/alternator/base
with this hook. Damage to the unit may occur.
CAUTION
: Do not damage the internal
generator wiring during this process.