Briggs & Stratton 1695360, Руководство оператора

Страница: 12 / 32

Not for
Reproduction
12
Assembly
Install Lock Plate -
Hydraulic Lift Models Only
NOTE: Non-labeled parts in Figure 5 & 7 are pre-existing.
1. Install the lock plate (FF, Figure 5) with existing pin and
additional pin (H). Secure with existing hair pin and
additional hair pin (I). The pre-existing washers are not
used with the lock plate.
FF
H
I
Hydraulic Lift
Models
Figure 5
Manual Lift Models Only
NOTE: The following section applies to tractors with factory
installed lift lever ONLY.
1. Place the lift lever in the attachment-raised (back)
position. Take note of the position of the spring through
the lift bar (GG, Figure 7). It will be required to reinstall
the spring through the lift bar.
2. Loosen the manual lift adjustment bolt (a, Figure 6) until
the bolt can be slid out of the groove in the bulkhead.
Remove the spring and bolt and set aside.
a
Figure 6
3. Remove the hair pin (b, Figure 7) and pin (c) securing
the spacer (d).
NOTE: If the lift bars are different, replace existing lift
bar with provided lift bar using existing hardware.
4. Re-install the pin from Step 3 through the top hole in
the lift cam (e), through the rear hole in the lift bar (GG),
spacer (d), and secure with the hair pin (b) as shown in
Figure 7.
GG
Manual Lift
Models
c
e
d b
Figure 7
5. Place the lift lever in the attachment-lowered (forward)
position.
6. Reinstall the lift assist spring in its original orientation.
7. Reinstall the manual lift adjustment bolt (Figure 6) in the
bulkhead and tighten.
Install Sub-Frame Hitch
1. Slide the sub-frame hitch (BB, Figure 8) under the
tractor.
NOTE: For 4 wheel drive tractors, insert push bar from
side of tractor instead of front.
BB
Figure 8