Briggs & Stratton 1695360, Руководство оператора

Страница: 11 / 32

Not for
Reproduction
11
Assembly
Bracket Installation
For 2013 Models & Proceeding Years
2-Wheel Drive / Right Side
1. Attached LEFT side of push bar (DD) to sub-frame hitch
(BB) as shown in Figure 2.
2. On the RIGHT side, insert capscrews (F, Figure 3)
through holes (shown in Figure 3) of sub-frame hitch
(BB), push bar latch (BB) and RH spring assist bracket
(EE). Secure with nuts (G).
BB
G
EE
DD
F
Figure 3
For 2013 Models & Proceeding Years
4-Wheel Drive / Right Side
1. Attached LEFT side of push bar (DD) to sub-frame hitch
(BB) as shown in Figure 2.
2. On the RIGHT side, insert capscrews (F, Figure 4)
through holes (shown in Figure 4) of sub-frame hitch
(BB), push bar latch (BB) and RH spring assist bracket
(EE). Secure with nuts (G).
G
EE
DD
F
BB
Figure 4
Install Lift Lever Kit
For tractors with non-manual or non-hydraulic factory
installed lift lever, use Lift Lever Kit 1694947.
Belt Installation
1. Verify belt part number (found on the back of belt) is
correct for your snowthrower.
- Single-stage snowthrower belt number is 1703371.
- Two-stage snowthrower belt number is 1703372.
2. Install correct belt for your snowthrower according to the
number listed above.
3. For correct belt installation, refer to Figure 38, page 20.
NOTE: Removal of belt may require loosening or
disassembly of L-shaped belt guide bracket from
pulleys 2 and 4.