Bri-Mar DI-100, Руководство пользователя

Страница: 5 / 16

5
• When it is necessary to mount through cross member, reinforce with steel
plate washers as illustrated in the installation diagram on page 7 of
installation manual.
• Use minimum of 3/8” bolts with lock washers and shake proof nuts.
• Bolt unit down.
9. Once unit is bolted down, drill hole through clamps and through dumper
sub-frame.
• Bolt clamp and sub-frame together using proper size bolts and lock-
washers (not provided).
• Clamps can also be tack welded to dumper sub-frame.
10. Cycle several times. Press the “Up” arrow on the hand control to raise
dump bed. Press the “Down” arrow on the hand control to lower the dump
bed.
11. Recheck all bolts to make sure unit is secure.
12. Raise unit and block up using prop rod.
• Unplug Remote cord and hand control from the pump.
• Mount hand control in cab of truck, following instructions on page 6 of
the instruction manual.
• Remote Control Box Must Be Mounted In Cab Of Truck. Unit Is Not
Waterproof And Extended Exposure To Moisture Will Cause Damage
to Control.
Your dump insert unit is now ready for use, please read notice below
before operating equipment.
DANGER
OPERATOR WARNING
DO NOT LOAD OVER 6000 POUNDS ON VEHICLE. DUMP INSERT
AND CARGO MUST NOT EXCEED MANUFACTURERS GROSS
VEHICLE WEIGHT RATING.
PRIOR TO SERVICING UNIT INSURE SAFETY PROP IS SECURE.
DO NOT PLACE ANY PART OF YOUR BODY UNDER DUMP UNIT
WITHOUT SAFETY PROP BEING SECURED.
DO NOT ATTEMPT TO SECURE PROP OR BLOCK DUMP BODY
UNDER LOADED CONDITIONS.
INSURE AT ALL TIMES THAT LOCKING MECHANISMS FOR
TAILGATE ARE PROPERLY ENGAGED.
DURING OPERATION OF DUMP INSERT, KEEP ALL BODY PARTS
CLEAR OF MECHANICAL OPERATING DEVICES, STRUCTURAL
SUPPORTS AND FASTENING SYSTEM.
FAILURE TO ADHERE TO THE MANUFACTURERS PUBLISHED
WARNINGS COULD RESULT IN LOSS OF CONTROL, SEVERE
PERSONAL INJURY OR DEATH.