9
Cleaning Instructions
Brewista recommends Cold Pro™ Cleaner for cleaning your Cold Pro Nitro 2™ System.
The Cold Pro Nitro 2™ needs to be cleaned every 24 hours as described in the steps
below. If it has not been used for a long period of time we recommend cleaning it per the
instructions below.
To clean your Cold Pro Nitro 2™ System:
1) Flush dispenser with water and then with air (emptying the lines) before
unscrewing and dismantling parts.
2) Unscrew spout (3) and rinse it with fresh water. Use a brush if needed to
remove any particles in the strainer. Reassemble tap parts [(1), (2), and (3)].
3) Disconnect the intake filter (13) and unscrew it for inspection. Use tools if
necessary as it is tightly screwed. Clean the internal net and then reattach
the cap. Reattach the pre-filter to the intake tube. Replace in the intake line
(11) after cleaning.
4) If used, disconnect your coffee container spout system, dismantle, and
clean it as well.
5) Add one teaspoon of Cold Pro™ Cleaner to one liter of water in a container
of your choice. Let the dispenser pull the solution through its lines as it
would with water or coffee until the solution leaves the tap. Release tap
handle to stop dispensing the solution.
6) Allow to sit for one hour.
7) Flush the dispenser with water before using it to dispense product.
8) Unscrew the entire tap at its base. Pull out the silicon tube and rinse well
with water. Re-insert the silicon tube and screw the tap back together once
complete. Note that the top part of the silicon tube is perforated and this
should be at the farther end inside the machine.
9) Switch off the air compressor and pull the tap handle (1) again. This
will release any internal pressure. Keep the intake tube (11) connected
throughout.
10) Check the quality of your coffee before serving.
Filter
Adapter
Parts
Cold Pro™
Cleaner
