Brew Monk 057.700.30, Инструкция по эксплуатации

Страница: 33 / 134

33
Instruction Manual Brew Monk - EN
2.5.2 Auto Mode Setting
1. Switch on the device, then press AUTO button.
2. S1 will be shown on the top left corner, input the 3 settings - TEMP , TIMER and POWER
(as in manual mode using “+” and “-“).
3. After you have set the 1
st
step, press AUTO button again, then enter into 2
nd
step
setting. 3
rd
to 9
th
steps are set as 1
st
and 2
nd
. For each step (3-9) press the AUTO button
to confirm and go to the next step.
4. Once TEMP is set to 100°C, it automatically changes from MASHING to BOILING.
5. Setting hop reminder in boiling process: After setting the TEMP , TIMER and POWER for
boiling, press AUTO . Set time for hop 1 using “+” and “-“. Press TIMER button for 2
nd
,
3
rd
, … hop reminder. For example: 60 minutes boiling and after 10 minutes first hop
addition, the hop reminder TIMER should be 50 minutes.
6. When you have entered the required steps (up to 9), press the START button to confirm
the above step settings. The brewing process will start. The current step will blink in the
upper left corner.
7. If 9 steps are too much for your recipe, set all temperatures below boiling by pressing
TEMP button after your last step. The programme only supports one boiling setting in
each recipe. You can adjust the boiling power during operation anytime.