4 Advanced Operations
Page 13
recommended to use high sensitivity degree in room or environment with little interference, and
to use lower sensitivity for outdoor or environment with lots of interference like hot wind, smoke,
near window etc. Furthermore, the sensitivity of the PIR is strongly related to the temperature.
Higher temperature leads to lower sensitivity. Therefore it is suggested to set a higher sensitivity
for high temperature environment.
It is recommended to use the “Low” setting for temperatures
below 3
5 degrees Fahrenheit and the “High” setting for temperatures exceeding 95 degrees
Fahrenheit.
The following shows how to set PIR sensitivity as
Low
provided that the previous option is
Normal
.
a) Press
MENU
to display the setting menu.
b) Press
UP
or
DOWN
to select
Sense Level
.
c)
Press
LEFT
or
RIGHT
to select
Low
.
d)
Press
OK
to save the current setting and the option will be un-highlighted.
Press
MENU
to cancel setting and return to info display.
4.1.12
Set Timer
This parameter defines a certain time lapse in a day when the Camera can be triggered. The
rest of the time the device is shut off. The effective value for the ranges from 00:00
：
00 to
23:59:59.
Please note that the start and stop time can only be effective when the timer is set as
On
.
Provided that the camera should work from eight a.m. to five p.m., the steps are as following:
a) Press
MENU
to display the setting menu.
b) Press
UP
or
DOWN
to select
Timer Switch
.
c) Press
RIGHT
to select
On
.
d) Press
OK
to enter into submenu.
e) Press
RIGHT
to select item, press
UP
or
DOWN
to change the value until the start time
changes to 8 and the stop time changes to 17.
f) Press
OK
to save all current setting and the option will be un-highlighted.
Press
MENU
to return to previous menu.
4.1.13
Set Flash Range
This parameter defines how many IR lights will work when the sunlight is not enough. I[(8n)-3(w)12(u)-3(d)6( )] TJETBT1 0 0 1 42.23 419.01 Tm[(co[(co[(cp)-5(s)10(e)1.13)] TJETBT/F3 12 Tf1 0.696 722.23 419.01 T1)-32a
