Bresser 7006200, Быстрый старт

Страница: 19 / 24

19 / 24
lished. If either of the devices is mains-powered, the power
supply must be disconnected for a short moment also for
this device when exchanging the batteries. If batteries are
exchanged in only one of the devices (i.e. the remote
sensor) the signal can’t be received or can’t be received
correctly.
Note, that the effective range is vastly affected by building
materials and position of the main and remote units. Due to
external influences (various RC devices and other sources
of interference), the maximum distance can be greatly re-
duced. In such cases we suggest to position the main unit
and the remote sensor at other places. Sometimes all it
takes is a relocation of one of these components of a few
inches! Though the remote unit is weather proof, it should
be placed away from direct sunlight, rain or snow.
7 Setting up power supply
Base station
1. Remove the battery compartment cover.
2. Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
3. Replace the battery compartment cover.
4. Wait until the indoor temperature is displayed on the
base station.
Remote sensor
1. Remove the silicone cover from the top edge down-
wards from the housing.
2. Loosen the screws at the battery compartment cover
with a small Philips screwdriver and remove the cover.