Bresser 7003100 000 000, Инструкция по эксплуатации

Страница: 25 / 40

25
Step 2
Place the nut in the hexagon hole on the sensor, then
insert the screw in other side and tighten it by the screw
driver.
Step 3
Insert the other side of the pole to the square hole of the
plastic stand.
NOTE:
Align the pole and stand marking.
Step 4
Place the nut in the hexagon hole of the stand, then
insert the screw in other side and then tighten it by the
screw driver.
Install the wireless 7-IN-1 sensor in an
open location with no obstructions above
and around the sensor for accurate
rain and wind measurement. Install
the sensor with the smaller end facing
the North to properly orient the wind
direction vane.
Secure the mounting stand and clamps
(included) to a post or pole, and allow
minimum 1.5m off the ground.
1.5 meter off
the ground
Point to
NORTH
Add rubber
pads before
mount on
the pole