Bresser 7001040, Инструкция по эксплуатации

Страница: 14 / 20

14 / 20
18 Feels like temperature
• This functionality requires a smartphone or tablet that meets the necessary hardware re-
quirements.
• An active Internet connection via Wi-Fi is required for this functionality.
The base station can use an app to graphically display information about the temperature felt in the
"Feels like" display area. (For more information on setting up this functionality, refer to the chapter
"Configuration / Setting up a WIFI connection")
The "Feels like" temperature indicates the temperature value according to the personal temperature
sensation.
19 MAX/MIN weather data
The maximum and minimum readings for indoor and outdoor temperature as well as for the humidity
are stored by the main unit over a period of 24 hours:
1. Press the MEM key several times to display the stored values one after the other.
2. Display sequence: Maximum readings (MAX) > Minimum readings (MIN) > Current readings
3. Press the MEM key for approx. 2 seconds to permanently delete all stored readings.
NOTICE! If a reading is below the recordable range, the display shows "LL.L". If a reading is
above the recordable range, the display shows "HH.H". Find more detailed information on the
recordable ranges in chapter "Technical data".
20 Temperature and humidity display from the
wireless sensor
After the power supply is established, the base station automatically searches for the radio signal from
the sensor. After the data transfer is complete, the temperature and humidity readings for the respect-
ive channel are shown on the display. This may take a few minutes.
The base station supports the connection of up to 3 compatible wireless sensors*. To retrieve the tem-
perature and humidity readings from different sensors, proceed as follows:
1. Press the UP/CH key several times to display the readings for the different sensors one after the
other. The corresponding sensor channel is shown in the display.
2. Press the UP/CH key several times until the symbol appears on the display next to the sensor
channel. The display alternates continuously between the sensor channels until a certain channel
is permanently set.
*1 pc. of wireless sensor included, others optionally available
21 Display brightness regulation
1. In battery-powered operation, touch the SNOOZE/LIGHT touch key to enable full display bright-
ness for about 15 seconds.
2. In mains power operation (DC 5V), press the Settings/Brightness key several times to set the de-
sired display brightness in 3 levels: low - medium - bright
NOTICE! In battery-powered operation, display brightness adjustment is not possible.
22 Technical data
Base station