brent Corner Auger, Руководство оператора

Страница: 76 / 80

4-14
INSTALL FLEX DRIVE
15. With both ratchets firmly mounted to
the side of the box, remove the finger
tight nut and bolt that holds the PVC
spacer on at the rear (red) end of the
roll tube. Holding the flex drive end
of the handle parallel to the roll tube,
slide the shaft into the end of the
tube protruding from the spool and
align the holes on the handle shaft
and the PVC spacer with the holes
on the tube. Reinsert the bolt and
tighten with the lock nut. See Fig. 14.
HAND CRANK HANDLE
251915-14
Fig. 14
DETERMINING TENSION
16. Cable tension is easily determined by
the position of the tension channel on
the front and rear spools.
As tension is applied with the ratchet,
the spool turns. Watch the tensioning
channel on the side of the spool -
proper tension is achieved when
the tension channel is level at the
bottom.
See Fig. 15.
CABLE TENSION
251915-15
Fig. 15
INSTALLATION TIP:
Tighten the ratchet an additional two
clicks past level. Then open and close
tarp system approximately five times.
This allows cable to seat in spool
grooves and tarp material to pull snug.
Now check tension channel. It should
be in the level position. Periodically
check tension level during use.
251915-16
Fig. 16
17. Locate the channel bracket holes just
above the box fold line, centered on
the box. Drill two 3/8" holes and use
screws with loctite, flatwashers, and
nuts to mount the channel bracket.
See Fig. 16. Attach the swivel crank
holder with fasteners to the channel
bracket.
Locate the operating decal near the
handle as shown. Clean the surface
and apply the sticker permanently.