brent Corner Auger, Руководство оператора

Страница: 10 / 80

1-10
HITCH PIN SIZE
A CLEVIS, RIGID (Scale Only) 1 1/4"
B SINGLE TANG SWIVEL (Scale Only) 1 1/2" / 2"
C SINGLE TANG SWIVEL (Non-Scale) 1 1/2"
D SINGLE TANG SWIVEL & HAMMERSTRAP (Non-Scale) 1 1/2"
1. Make sure the flow control door is in the closed position before loading into the
cart.
2. Engage PTO at a low RPM; increase tractor RPM to desired speed.
3. Open the flow control to desired rate.
4. Use the flow control opening to slow the rate of the flow rather than the tractor's
RPM.
NOTE: If overload causes the clutch to slip (standard PTO drive) or
motor to stall (hydraulic drive), stop auger immediately. Excessive heating of the
clutch will require replacement of internal parts. Close flow control door and
relieve auger unload pressure by opening bottom pit dump door to remove some
grain from auger.
5. It is not advisable to disengage the auger with the flow control open. Excessive
start-up torque may result, putting stress on the cart driveline and your tractor.
6. Properly identify the tractor remotes as to hook-up the flow control and auger
fold. A mix-up can damage the auger drive system.
7. Under any circumstances, DO NOT enter the cart with the auger or tractor
running.
8. When folding the auger into the unloading position, make sure you have given
sufficient time for the cylinder to rotate the bell crank into an over-center
position.
9. It is strongly advised that the unloaded auger always be returned to the transport
position when not in use.
OPERATION IN FIELD
TRACTOR HOOK-UP
HYDRAULIC HOOK-UP
-- Properly identify the hoses for the auger fold and the flow control operation.
-- It is advisable to use the hydraulic control lever closest to the operator (most
commonly known as control lever No. 1) to activate the flow control.
-- Make sure sufficient counter-weight is used on the tractor's front-end.
-- Move draw bar into closest position for even terrain.
-- Make sure draw bar length and PTO telescoping limits are adequate for
uneven terrain, gullies, rice levees etc.
-- Never exceed the maximum recommended hitch pin size which allows for
uneven terrain. See Chart below.
-- Install hardened washer of hitch pin diameter between bottom of swivel ball
and tractor draw bar.
250960
•
• 04-16-01
•
IMPORTANT!!
USE FULL SIZE
PIN IN BALL SWIVEL.
FAILURE TO USE THE
RECOMMENDED HITCH
PIN SIZE AND APPROPRI-
ATE WASHER CAN CAUSE
PREMATURE FAILURE OF
SWIVEL BALL AND
TRACTOR DRAWBAR.