brent Corner Auger 1080, Руководство оператора / Каталог запчастей

Страница: 81 / 138

4-9
Initial Set-up
3. Insert the small 1" tube by sliding
it into the small pocket of the tarp.
Align the holes at one end and fasten
with arivet. At the other end, pull on
the tarp by hand to stretch it until the
holes match. Install remaining rivets.
See Fig. 8.
INSTALLATION TIP:
Tarp is designed to be stretched the length
of the tube to reduce wrinkling. For easier
assembly apply liberal dusting of baby
powder on tube and inside of tube pockets
before sliding tubes in pockets.
• Ridge Strap, Tarp, Tubes
1. Attach the hooks on each end of the
two ridge strap assemblies to the holes
in the center of the end caps. Run the
straps over the top of the bows (2).
Draw the straps snug tight with ratchets.
Do not overtighten . See Fig. 6.
2. (2-person operation) On a clean
fl oor, lay the tarp out fl at with the
rope in the large pocket to the
bottom, (raw edge of the hems and
pockets down) and the exterior side
facing up. There is a hole about
4 1/2" from each end of the roll tube
and a hole about 1 1/2" in on each
end of the large pocket.
Match the roll tube channel with the sewn-in rope on the tarp pocket. The tube holes and
tarp holes must be on the same side of the rope to line up. Slide the tube into the tarp
pocket, making certain that the rope is fully engaged in the rope channel on the tube. Align
the holes at one end, insert the large fl ange rivet and fasten. On the other end, by hand,
pull on the tarp to stretch it until the holes on the tube and tarp line up, then insert rivet
and fasten. See Fig. 7 & 8.
Fig. 8
Fig. 6
Fig. 7
251915-7
251915-8
251915-6
Revised 061107-12