brent 1082, Руководство пользователя

Страница: 44 / 126

Brent 1082/882
— Operation
3-10
Auger Operation
PTO Driven Auger
• ELECTROCUTION WILL CAUSE SERIOUS INJURY OR DEATH. THE
GRAIN CART IS NOT INSULATED. KEEP AWAY FROM ALL ELECTRI-
CAL LINES AND DEVICES. ELECTROCUTION CAN OCCUR WITHOUT
DIRECT CONTACT.
• ENTANGLEMENT WITH THE DRIVELINE WILL CAUSE SERIOUS INJURY OR DEATH.
KEEP ALL GUARDS AND SHIELDS IN GOOD CONDITION AND PROPERLY INSTALLED
AT ALL TIMES. AVOID PERSONAL ATTIRE SUCH AS LOOSE FITTING CLOTHING, SHOE
STRINGS, DRAWSTRINGS, PANTS CUFFS, LONG HAIR, ETC. THAT CAN BECOME EN-
TANGLED IN A ROTATING DRIVELINE.
1. Before loading cart or operating auger, verify
that the fl ow control door is closed.
2. Choose an area free from obstructions and un-
fold auger into unloading position. Allow suf-
fi cient time for the cylinder to fully engage the
two augers.
3. Engage PTO at low RPM, then increase the
PTO RPM to about 1000 RPM.
4. Open fl ow control door to desired unloading rate. Numbers on the auger tube provide a point of
reference for operator convenience.
NOTE: If an overload occurs, (Shear-bolt failure or excessive heat/smoke from friction clutch)
stop auger immediately. Close fl ow control door and relieve auger grain pressure by opening
bottom door to remove some grain from auger before resuming.
5. To slow or stop grain fl ow, close fl ow door, rather than reducing tractor RPM. Close fl ow door fully
when unloading is complete.
NOTE: It is not recommended to disengage auger with fl ow control door open. Auger system
will require substantially more torque to start, placing extra stress on both cart and tractor
driveline.
6. Stop PTO. After the PTO has come to a complete stop, fold auger to the transport position.
(November 2014)