18
Ussc
WARNINGS
• NEVER OVERFIRE YOUR STOVE. IF ANY PART OF THE STOVE STARTS TO GLOW RED, OVER
FIRING IS HAPPENING. READJUST THE AIR INTAKE CONTROL AT A LOWER SETTING.
• THE INSTALLATION OF A LOG CRADLE OR GRATES IS NOT RECOMMENDED IN YOUR WOOD
STOVE. BUILD FIRE DIRECTLY ON FIREBRICK.
• NEVER PUT WOOD ABOVE THE FIREBRICK LINING OF THE FIREBOX.
RELOADING
Once you have obtained a good bed of embers, you should reload the unit. In order to do so, open the air
controls to maximum a few seconds prior to opening the stove’s door. Th
en proceed by opening the door very
slowly; open it one or two inches for 5 to 10 seconds, before opening it completely to increase the draft and thus
eliminate the smoke which is stagnant in a state of slow combustion in the stove. Th
en bring the red embers to
the front of the stove and reload the unit.
For optimal operation of your wood stove, we recommend you to operate it with a wood load approximately
equivalent to the height of fi re bricks. Do not build the fi re where the logs can roll and strike the glass or roll
out of the stove during loading.
It is important to note that wood combustion consumes ambient oxygen in the room. In the case of negative
pressure, it is a good idea to allow fresh air in the room either by opening a window slightly or by installing a
fresh air intake system on an outside wall.
Creosote - Formation and Need for Removal - When wood is burned slowly, it produces tar and other organic
vapors, which combine with expelled moisture to form creosote. Th
e creosote vapors condense in the relatively
cool chimney fl ue of a slow-burning fi re. As a result, creosote residue accumulates on the fl ue lining. When
ignited this creosote makes an extremely hot fi re. Th
e chimney connector and chimney should be inspected
at least once every two months during the heating season to determine if a creosote build-up has occurred. If
creosote has accumulated (3mm or more), it should be removed to reduce the risk of a chimney fi re.
We strongly recommend that you install a magnetic thermometer on your smoke exhaust pipe, approximately
18” above the stove. Th
is thermometer will indicate the temperature of your gas exhaust fumes within the
smoke exhaust system. Th
e ideal temperature for these gases is somewhere between 275°F and 500°F. Below
these temperatures, the build-up of creosote is promoted. Above 500 degrees, heat is wasted since a too large
quantity is lost into the atmosphere.
TO PREVENT CREOSOTE BUILD UP
• Always burn dry wood. Th
is allows clean burns and higher chimney temperatures, therefore less creosote
deposit.
• Leave the air control full open for about 5 min. every time you reload the stove to bring it back to proper
operating temperatures. Th
e secondary combustion can only take place if the fi rebox is hot enough.
• Always check for creosote deposit once every two months and have your chimney cleaned at least once a year.
If a chimney or creosote fi re occurs, close all dampers immediately. Wait for the fi re to go out and the heater to
cool, then inspect the chimney for damage. If no damage results, perform a chimney cleaning to ensure there
is no more creosote deposits remaining in the chimney.
Содержание SW4100
Страница 22: ...22 Ussc NOTES...
Страница 23: ...Ussc 23 NOTES...
