AWT35-501815 Issue AB C3236_u_en_501815.docx
Page 7
2. Introduction
The C3236 is a high resolution stainless steel IP68 wash-down scale ideal for general food weighing,
portion control or checkweighing applications. This scale offers a fast weight indication along with an
easy to use Under, Over and Acceptable weight indication. Ideal for most food processing
environments or where weighing needs to take place in a clean wet environment.
This manual covers the introduction to the unit, its use, configuration and calibration.
2.1 Unpacking
Carefully take the scale out of
its package, make it sure it’s not damaged and all accessories are
included.
•
Remove the scale from the carton
•
Remove the protective covering
•
Inspect the scale and terminal for damage
•
Make sure all components are included:
1. C3236 Scale
2. Adaptor plus plug adaptors
3. Weight Platter
2.2. General Installation Guidelines
To get the best performance from the scale try to place the C3236 in a location that will not degrade
its accuracy.
•
Avoid extremes of temperature. Try to avoid placing the scale in direct sunlight or near air vents.
.
•
Place the scale on a level flat surface. Do not place the scale near vibrating machinery
•
Avoid unstable power sources. Do not use near large users of electricity, e.g. welding equipment.
2.3. Levelling the Scale
Level bubble is located at the front left corner of the display.
•
Place the scale on a level flat surface.
•
The level bubble should be centered inside the inner ring.
•
If the scale is not level, adjust the levelling feet until the level
bubble is centered correctly.
Always check the level prior to using scale.
2.4. Battery Operation
To charge the 6V 4Ahr battery, plug in the supplied power adaptor into an AC power outlet and attach
the DC wash-down connector end to the scale (Fig. 1). The scales DC water proof connector can be
found under the scale near the battery compartment, slide back the bottom battery cover and pull out
the DC charging lead with water proof connector and attach it to the supplied power adaptor.
This water proof connector has a key that has to be lined up so it can only be plugged in in one
direction. Close the battery lid making sure the lead is not trapped and turn on the scale
Please note the scale does not need to be turned on to charge the battery. The battery should be
charged for at least
6hrs
to fully charge the battery.
