BRAYER BR3021BK, Инструкция по эксплуатации, Страница: 6 / 28

6 EN
WALL-MOUNTED HOLDER OF THE
HAIRDRYER
To reduce the risk of electric shock, do not hang
the wall-mounted holder (6) in places where the
hairdryer can fall into a bath or a sink.
• Remove the back plate from the holder (6).
• Mark out the places for drilling, drill the holes and
insert plastic wall plugs. Fix the back plate with the
screws.
• Install the holder (6) on the back plate until the locks
clicking.
• Insert the hairdryer into the wall-mounted holder (6).
USING THE HAIRDRYER
• Insert the power cord (8) plug into the mains socket.
• Take the hairdryer by the handle and remove it from
the wall-mounted holder (6).
• Use the switch (1) to set the required operation
mode:
- «0» — the hot air styler is switched off;
- «1» — warm air supply;
- «2» — hot air supply.
• The button (2) is the cool shot function « », press
and hold down the «cool» shot button for fixing your
hairstyle.
• Note: during the first operation a foreign smell and a
small amount of smoke can appear from the heating
element, this is normal and it is not covered by
warranty.
• After unit operation, switch the hairdryer off by setting
the switch (1) to the position «0», insert the hairdryer
into the wall-mounted holder (6).
•
Note:
during the breaks between drying and styling
your hair you can insert the hairdryer into the wall-
mounted holder. The hairdryer will switch off. Remove
the hairdryer from the holder (6), and the hairdryer will
switch on in the preset operating mode.
NOZZLE
• Use the nozzle (3) when you need to focus the power
of drying on a small area (for example, a curl or a wave)
or when you want to straighten wavy hair.
• When the desired effect is achieved, press the cool
shot button (2) « » and fix your hairstyle.
OVERHEATING PROTECTION
• Overheating protection switches the hairdryer off if the
outgoing air is too hot.
• If the hot air styler is switched off during operation, set
the switch (1) to the position «0», unplug the unit and
make sure that the air inlets and outlets are unblocked.
• Let the unit cool down for 5-10 minutes and switch it on
again. Do not block the air inlets during operation of the
hot air styler and avoid getting of hair into the air inlet
grid (5).
CLEANING AND MAINTENANCE
• Set the switch (1) to the «0» position and let it cool
down.