BRAYER BR1703, Инструкция по эксплуатации, Страница: 7 / 44

7 EN
• Disassemble the Juicer and wash the parts that
come into contact with fruit and vegetables when the
Juicer is in use.
• Remove the pusher (1) from the feeding chute (2).
• Rotate the Feeding Chute/Lid (2-3) counter-clockwise
and remove it.
• Remove the Auger (4), Mesh Filter (5), and Separator
(6) from the Juice Bowl (7).
• Rotate the Juice Bowl (7) counter-clockwise and
remove it from the Motor Unit (8).
• Wash the removed parts (2-3, 4, 5, 6, 7), the juice
cup (13), the pulp container (14) and the cleaning
brush (15) with warm water and a neutral detergent,
then rinse and dry.
• Wipe the motor unit (10) with a slightly damp cloth,
then dry.
JUICE EXTRACTOR ASSEMBLING
• Place the juice extractor on an even, dry and stable
surface so that an electrical outlet is always easily
accessible.
• Before assembling the Juicer, make sure that the
Silicone Seal (12) inside the Juice Bowl (7) has been
properly reinstalled (fig. 1).
Note: the Silicone Seal (12) must be firmly fixated in its
place, otherwise juice may leak from the Juice Bowl (7)
during usage and cause damages to the Juicer.
• Place the Juice Bowl (7) onto the Motor Unit (10)
and rotate it in the clockwise direction all the way in
(fig. 2).
• Insert the Mesh Filter (5) into the Separator (6) (fig. 3).
• Align the « » red mark on the Mesh Filter with the «
» red mark on the body of the Juice Bowl (7) and
install the Mesh Filter (5) into the Juice Bowl (7).
Make sure that the Mesh Filter (5) has been installed
properly and secured in place (fig. 4).
• Install the Auger (4) into the Mesh Filter (5); the Auger
(4) should secure itself on the driving shaft (fig. 5).
• Install the Feeding Chute/Lid (2-3) onto the Juice Bowl
(7), align the « » red mark on the Feeding Chute/Lid
(2-3) with the « » red mark on the body of the Juice
Bowl (7), and rotate the Feeding Chute/Lid (2-3) in the
clockwise direction all the way in (fig. 6). Make sure
that the Feeding Chute/Lid (2-3) has been properly
secured.
• Insert the pusher (1) into the feeding chute (2) (pic. 7).
• Place the Juice Container (13) under the Juice Spout
(9), place the Pulp Container (14) under the Pulp
Spout (8).
• The juice exractor is ready for use.
TIPS
• The Juicer is not intended for extracting juice from
fruits, containing high levels of pectin or starch, such
as bananas, papayas, figs, avocados, and etc.,
bananas contain little to no juice, only add them for
the scent.
• Fruit with softer seeds, such as apples, grapes,
oranges, and so on, can be juiced without removing
the seeds, however, adjust the amount of fruit being