BRAYER BR1108, Инструкция по эксплуатации, Страница: 18 / 80

18 EN
flashing. After preheating the button (25) « » and
(26) « » indicators will glow constantly.
11. Repeat the cleaning procedure for the steam
release channels described in the paragraph 10.
12. Perform the steps 8 and 9 with small intervals until
the water tank (9) becomes empty.
13. Switch the coffee maker off by pressing the button
(23) «ON».
14. Fill the tank (9) with clear water up to the maximal
mark, and repeat the steps 8, 9 not less than 3
times without the 10-15 minute break.
15. Clean the steam release channels from the
cleaning solution, paragraph 10.
16. Switch the coffee maker off by pressing the button
(23) «ON».
Note: to remove the scale you can use descaling
agents for coffee machines, strictly following the
instructions on their usage.
CLEANING THE COFFEE MAKER
• Switch the coffee maker off and wait until it cools
down completely.
• If there is some ground coffee remaining in the filter
(21) openings, clean the filters (21) with a small
brush.
• Drops of ready coffee may leak from the anti-drip
valve of the drip coffee maker and fall onto the
warming tray (20) of the flask (18). To avoid drops
getting on the tray (20) during coffee making, do not
remove the flask (18) from the tray for a long time.
• If some coffee drips on the tray (20), wipe it with a
paper towel or a dry cloth.
• After you finish using the drip coffee maker, wipe the
tray (20) with a damp cloth. Do not use abrasives to
clean the tray (20).
• Clean the coffee maker body (17) with a soft, slightly
damp cloth and then wipe the body (17) dry. Do not
use abrasives and solvents for cleaning the coffee
maker.
• Do not immerse the coffee maker body (17), the
power cord and the power plug into water or any
other liquids.
• Wash the removable parts of the coffee maker with
warm water and neutral detergent, then rinse them
and dry.
Drip tray
• A red pop-up indicator (1) in the grid (2) will show
when the tray is full.
• Remove the grid (2) from the tray, remove the tray
and pour out water, install the tray back to its place,
put the grid (2) on the tray.
• If necessary, wash the tray and the grid (2) with water
and soft detergent, rinse and dry.