BRAYER BR1107, Инструкция по эксплуатации, Страница: 11 / 76

11 EN
Notes:
- if you need to switch the coffee maker off during the
espresso making, press the «Espresso»-button (7)
again;
- successive making of coffee should be performed
with intervals 2-3 min.
• Remove the cup with ready drink from the grid (2 or 3).
• After you finish using the coffee maker, switch the
coffee maker off by setting the switch (11) «0/I» to the
position «0».
• Wait until the coffee maker cools down, remove the
filter holder (18) and wash the installed filter (19 or 20).
ESPRESSO PORTION SETTING
• When making espresso, press and hold the button
(7) « » for 3 seconds, the one cup indicator « » will
be flashing. When the desired amount of espresso is
dispensed, release the button (7). The maximal amount
of one cup of coffee is about 90 ml.
• Next time when you make espresso, the preset amount
of ready coffee will be poured into the cup.
• When making espresso, press twice and hold the
button (7) « » for 3 seconds, the two cups indicator
« » will be flashing. When the desired amount of
espresso is dispensed, release the button (7). Maximal
amount of double portion of coffee is about 130 ml.
• Next time when you make espresso, the preset amount
of ready coffee will be poured into the cup
Notes:
- minimal and maximal amount of espresso
are specified in the table «CHOOSING THE
APPROPRIATE CUP»;
- if you need to make a lesser amount of coffee then it
was set, press the button (7) again when the cup is
filled with necessary amount of ready coffee.
Return to the factory settings
• To return to the factory settings switch the coffee maker
off by setting the switch (11) «0/I» to the position «0».
• Press and hold the button (5 7) «Espresso», switch the
coffee maker on by setting the power switch (8) «0/I»
to the position «I», the buttons « » and « » indicators
will flash 5 times.
• The coffee maker is ready for operation with the factory
settings.
MAKING CAPPUCCINO
ATTENTION! When making cappuccino be careful to
avoid burns by outgoing hot steam.
• Make sure that the removable tray (1) and the tray grid
(2) are installed to their places.
• Fill the tank (10) with cold water, do not exceed the
maximal level mark, install the tank (10) back to its
place.
• Take the container (16), pull it towards yourself and
remove it (pic. 1), remove the cappuccinator lid (14)
from the container (16).