BRAYER BR1106, Инструкция по эксплуатации

Страница: 6 / 56

6 EN
• Transport the coffee maker in the original package.
• Keep the unit out of reach of children and disabled
• persons.
COFFEE MAKER IS INTENDED FOR HOUSEHOLD
USE ONLY, DO NOT USE THE COFFEE MAKER FOR
COMMERCIAL OR LABORATORY PURPOSES.
BEFORE USING THE COFFEE MAKER
After unit transportation or storage at low
temperature, it is necessary to keep it for at least
three hours at room temperature.
• Unpack the coffee maker and remove all the
packaging materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the coffee maker for damages, in case of
damage do not plug it into the mains.
• Make sure that the specifications of power supply
voltage specified on the label correspond to the
specifications of your mains. When the unit is used in
the mains with 60 Hz frequency, it does not need any
additional settings.
• Wipe the surface of the coffee maker body with a
clean, slightly damp cloth to remove dust.
• Make sure that the control buttons (8, 9) are in the
off position.
• Make sure that the steam supply is closed. To do this
turn the knob (16) « / » to the position « ».
• Before using the coffee maker for the first time, wash
all removable parts (1, 2, 5, 6, 15, 20) with warm
water and neutral detergent, rinse and dry them.
• Remove the water tank (15), fill it with cold water up
to the MAX mark and install it back to its place.
• Install the coffee filter (6) (do not add ground coffee
into the filter) into the holder (5) having preliminary
matched the ledge on the filter (6) with the groove on
the holder (5) and turn the filter (6) counter/clockwise
to fix the filter.
• Install the filter holder (5) into the coffee maker. The
holder (5) ledges should match the grooves on the
boiler « », after that turn the filter holder handle
(3) to the right until bumping « ».
• Place a suitable cup on the grid (2).
• Insert the power plug into the mains socket.
• Switch the coffee maker on, setting the power switch
(19) to the «I» position, the indicator (11) will light up,
and the ready indicator (10) will start flashing.
• To fill the boiler with water press the button (9) «
», wait for 15-20 seconds, or at the first signs
of appearance of water in the cup, switch the water
supply off by pressing the button (9) « » again.
• Wait until the indicator (10) glows constantly, then
switch the water supply on by pressing the button
(9) « ». After the cup is filled with water, press the
button (9) « » again to switch the water supply off