BRAYER BR1092, Инструкция по эксплуатации

Страница: 9 / 44

9 EN
Additional information
• The thermopot is equipped with rotating base (12).
You can turn the thermopot body (10) in the required
direction.
• Check the water level in the thermopot using the
scale (1).
• Timely refill the thermopot.
• If the water temperature goes significantly below
the preset temperature (for example, if you added
cold water), the boiling mode will switch on and the
indicator (16) «Boiling» will light up.
• You can switch the reboiling mode on by pressing the
button (18) «Reboiling», the indicator (16) «Boiling»
will light up. After boiling the water the indicator (16)
«Boiling» will go out and the keep warm mode will
switch on.
CLEANING AND MAINTENANCE
• Before cleaning the thermopot unplug it, open the
lid (4) and wait until the thermopot cools down
completely.
• Always drain the remaining water from the thermopot
flask, to do this remove the lid (4).
• Before removing the lid (4) open it, press on the lock
(15) above, take the button (5) and remove the lid (4)
by pulling it towards the control panel (3) (pic. 6).
• Carefully tilt the thermopot to drain the remaining
water (pic. 7).
• Install the lid (4) back to its place. To do this, set the
lid (4) at a small angle, press the lock (15) and insert
the lid (4) to its installation place. Release the lock
(15). Before using the thermopot make sure that the
lid (8) is fixed properly with the lock (15).
• Clean the outer surface of the thermopot body (10)
with a slightly damp cloth and then wipe it dry.
• Use neutral detergents to remove dirt, do not use
metal brushes, abrasives and solvents.
• Do not immerse the thermopot and the power cord
(20) into water or other liquids.
• Do not put the thermopot in a dishwashing machine.
Stains on the inner surface of the thermopot flask
• Water contains various minerals that can cause
stains on the inner surface of the thermopot flask, the
stains do not affect the operation of the thermopot,
stains are not covered by the warranty.
• You can remove the stains from the inner surface of
the thermopot flask with citric acid solution or table
vinegar.
• To remove the flavour of citric acid or vinegar, boil
water and pour it out.
• Repeat this procedure until the smell and foreign
taste vanish completely.
Removing the mineral deposits (descaling)
• Scale, appearing inside the thermopot flask,
influences the water taste and disturbs the heat
exchange between water and the heating element.